Polling status

[FatMax]

I´m scratching my head a bit concerning what to do if there is a fire alarm. Obviously, it´s fairly easy to turn off things that need to be turned off.

My concern regards lights. Is there a way, in a script, to poll every lights current status and save that state if the group address for the firearm goes true? 

The scenario would be this:

Fire alarm goes off. Every appliance turns off and all lights go to 100%. 3 minutes after the fire alarm has been reset, the lights go back to the state they were in before the fire alarm went off.

I´m not even sure if this is what people do when it comes to KNX and fire alarms...

what we do:
- connect all devices to a scene
- when firealarm on: save scene - turn lights on / blinds up
- when firealarm off: call scene

Thanks for the tip! Haven't worked too much with scenes yet. What you are saying is that you can save scenes on the fly with KNX, and not have to pre-program these in ETS?