09.07.2015, 13:45
(This post was last modified: 09.07.2015, 21:57 by PassivPluss.)
Hi.
I cannot get the modbus to work correctly to communicate with iEM3155 on Modbus, parameters inserted correctly but there is no place to choose stop bits in LM, the iEM has 1 stop bit. Is that OK?
I tried to modify the Json file to the correct settings for reading adresses but i only get 0 value. I tried one up and one down register also. Any ideas?
i can also add that the iEm3155s Communication LED blinks when trying to read registers.
I cannot get the modbus to work correctly to communicate with iEM3155 on Modbus, parameters inserted correctly but there is no place to choose stop bits in LM, the iEM has 1 stop bit. Is that OK?
I tried to modify the Json file to the correct settings for reading adresses but i only get 0 value. I tried one up and one down register also. Any ideas?
i can also add that the iEm3155s Communication LED blinks when trying to read registers.