20.12.2015, 19:01
Hello everyone!
I'm new here, just got my Re:actor V2. Sort of jumped into it after considering using Loxone for a while. Changed my mind due to obvious reasons...
So, I'm just trying to understand the logics of this system. Tried addressing group addresses on the knx bus, and that works, no problem.
But if I want to address a specific group object, how should I do that? Say if the device is 1.1.2 and the input/output is 18.
Please keep in mind my programming skills are quite basic at the moment
I'm new here, just got my Re:actor V2. Sort of jumped into it after considering using Loxone for a while. Changed my mind due to obvious reasons...
So, I'm just trying to understand the logics of this system. Tried addressing group addresses on the knx bus, and that works, no problem.
But if I want to address a specific group object, how should I do that? Say if the device is 1.1.2 and the input/output is 18.
Please keep in mind my programming skills are quite basic at the moment