This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.

Modbus-knx tp filter
#1
Hi everyone!

I mapped some Modbus device registers to some knx adresses, but i don't want the LM5 to send the values to the knx bus (TP). I have tried using the filtering in "knx connection" and exclude the range I don't want to send too, on the knx bus, (24/*/* and 25/*/*). But when I hit the ok button, the filter get's cleared.

Any ideas?

B,R 

BA
Reply


Messages In This Thread
Modbus-knx tp filter - by BuildingAutomation - 02.03.2018, 22:57
RE: Modbus-knx tp filter - by admin - 03.03.2018, 05:57
RE: Modbus-knx tp filter - by admin - 05.03.2018, 08:06

Forum Jump: