17.03.2018, 12:18
I am using Zennio KLIC-DA interfaces for Daikin Altherma heat pumps.
This interface is supposed to be able to read the energy consumption and production of the heat pump. I discovered that these readings only took place after using the control panel on the heat pump which is of course not the idea of Smart Home...
Zennio were unaware of this because they always tested their system in combination with the control panel...
I filed a ticket with Zennio and this issue was referred to their engineering department. However, after eight months they have not produced an update of their ETS application program...
I discovered that when I reset the device it would read the energy values, so this seemed a good intermediate solution. Further testing however revealed that resetting the interface caused the heat pump to switch off or revert to cooling instead of heating...
I also have had occasions with Basalte Auro movement sensors that would get 'stuck' and needing a reset...
This interface is supposed to be able to read the energy consumption and production of the heat pump. I discovered that these readings only took place after using the control panel on the heat pump which is of course not the idea of Smart Home...
Zennio were unaware of this because they always tested their system in combination with the control panel...
I filed a ticket with Zennio and this issue was referred to their engineering department. However, after eight months they have not produced an update of their ETS application program...
I discovered that when I reset the device it would read the energy values, so this seemed a good intermediate solution. Further testing however revealed that resetting the interface caused the heat pump to switch off or revert to cooling instead of heating...
I also have had occasions with Basalte Auro movement sensors that would get 'stuck' and needing a reset...