12.07.2018, 10:57
Thanks for your advice. I've checked this now (and also before) and on profile F6-01-01 relay works strange e.g. something clicked but nothing change (multimeter is connected to relay in beep when there is connection between IN-O).
On profile F6-01-03 all is good with sending command from LM to wallplug.
I think that there is eventually a problem with this profile:
F6-04-01 as EnOcean->KNX
or maybe there is an issue with translating commands into KNX (maybe 2 are generated because filter should work and it isn't)
On profile F6-01-03 all is good with sending command from LM to wallplug.
I think that there is eventually a problem with this profile:
F6-04-01 as EnOcean->KNX
or maybe there is an issue with translating commands into KNX (maybe 2 are generated because filter should work and it isn't)
Done is better than perfect