This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.

Modbus Double datapoint type
#5
OK thank you very much

I have another doubt, I have modbus variables that are int32 variables of temperature or power values multiplied by 10, I have tried to use the option to adjust these values in the Modbus definition using 0.1 but I do not know what type of data I have to use in KNX to represent a 32-bit float value. The only option that I have found was to create a new variable and make an intermediate script that divides me by 10 the value read from Modbus. Thank you very much. a greeting
Reply


Messages In This Thread
Modbus Double datapoint type - by josep - 30.07.2018, 19:01
RE: Modbus Double datapoint type - by admin - 31.07.2018, 06:58
RE: Modbus Double datapoint type - by josep - 31.07.2018, 07:43
RE: Modbus Double datapoint type - by admin - 31.07.2018, 08:41
RE: Modbus Double datapoint type - by josep - 31.07.2018, 17:04
RE: Modbus Double datapoint type - by admin - 01.08.2018, 06:51
RE: Modbus Double datapoint type - by Ibrahim - 18.11.2020, 13:07
RE: Modbus Double datapoint type - by admin - 18.11.2020, 14:02
RE: Modbus Double datapoint type - by Ibrahim - 20.11.2020, 05:46

Forum Jump: