03.08.2018, 09:07
OK so you have 2 lines and both are connected over Ethernet. In this case you should not use 1.0 and 1.1 only 1.1 and 1.2
1.0 is used only in standard KNX TP topology with main line.
When HL is connected to TP always use TP-UART mode. Mode define how HL is connecting to KNX.
BR
1.0 is used only in standard KNX TP topology with main line.
When HL is connected to TP always use TP-UART mode. Mode define how HL is connecting to KNX.
BR
------------------------------
Ctrl+F5
Ctrl+F5