24.09.2018, 14:59
I have problems when programming a device address in ETS5 with my homelynk (2.3.0). Application programming works great.
I received: more than one device is in programming mode, but thats not true.
When i disconnect my HL from the knx bus and when i add a usb programming device it works.
When i do a device programming check in ets it gives: 15.15.255(*2)
------------------------------------------------------------------
Quick and dirty topology is added as attachement.
I have one head line 1.0
3 sublines after a jung line coupler 1.1, 1.11, 1.13
Line 1.1 has a lot of devices, so also a jung repeater is added.
Also my HL ip and knx settings are added as attachement.
How to solve this?
I received: more than one device is in programming mode, but thats not true.
When i disconnect my HL from the knx bus and when i add a usb programming device it works.
When i do a device programming check in ets it gives: 15.15.255(*2)
------------------------------------------------------------------
Quick and dirty topology is added as attachement.
I have one head line 1.0
3 sublines after a jung line coupler 1.1, 1.11, 1.13
Line 1.1 has a lot of devices, so also a jung repeater is added.
Also my HL ip and knx settings are added as attachement.
How to solve this?