25.09.2018, 06:09
(This post was last modified: 25.09.2018, 06:15 by gjniewenhuijse.)
(24.09.2018, 16:46)domotiqa Wrote: try homelynk on 1.0, then unplug all line. And test every time you plug each line !
Already tested, but no solution.
When the HL is connected i receive this message.
(24.09.2018, 17:36)Erwin van der Zwart Wrote: Hi,
Couplers always need address 0 and repeaters are typically given there correct topological address 64, 128 and 192 so the addresses like 1.1.11, 1.1.13 and 1.1.100 are invalid..
Your line couplers need to be 1.1.0, 1.2.0, 1.3.0 and your repeaters 1.1.64, 1.2.64, 1.3.64
BR,
Erwin
You're right, this is already the case, except the repeater.
Couplers have the follow addresses:
line 1.1, address 1.1.0
line 1.11, address 1.11.0
line 1.13, address 1.13.0
Repeater on 1.1.64 or 1.1.128 doesn't matter. I disconnected the whole line and the problem existst.
And with another ip or usb programming device it works great.