ets more than one device is in programming mode

[buuuudzik]

try homelynk on 1.0, then unplug all line. And test every time you plug each line !

Already tested, but no solution.

When the HL is connected i receive this message.

---

Hi,

Couplers always need address 0 and repeaters are typically given there correct topological address 64, 128 and 192 so the addresses like 1.1.11, 1.1.13 and 1.1.100 are invalid..

Your line couplers need to be 1.1.0, 1.2.0, 1.3.0 and your repeaters 1.1.64, 1.2.64, 1.3.64

BR,

Erwin

You're right, this is already the case, except the repeater.
Couplers have the follow addresses:
line 1.1, address 1.1.0
line 1.11, address 1.11.0
line 1.13, address 1.13.0
Repeater on 1.1.64 or 1.1.128 doesn't matter. I disconnected the whole line and the problem existst.

And with another ip or usb programming device it works great.

I've learned on KNX advanced course that with some repeaters it could be important to address properly all devices so devices before first repeater(1.1.64) should have addresses from 1.1.1-63, and after it should have addresses from 1.1.65-127 etc.