ets more than one device is in programming mode

[gjniewenhuijse]

Hi Gert Jan,

When you have 2 devices in the same line that has a TP and also a IP connection you create a loop, any telegram on the TP is repeated on the IP side and then the other device puts it from IP to the TP again (infinity loop). Basically you create a double line/backbone. Only solution to this is disable KNX IP in one of the 2 devices.

BR,

Erwin

Only the HL has a TP connection.

The other device has a non multicast connection to the HL. When i change this to a multicast connection it works. Very strange.