Thank you very much.
I will give it a try and report back.
I have successfully add a user library with those functions and then have send a "NRC_POWER-ONOFF" code to the TV and it worked!! Thank you very much!
I will now try to complete the rest of the commands and - if possible - to create a simple panel to simulate the remote control via the LM visualization!
One last question, since this TV is not powered via a bus-controlable outlet, and also does not support any wake-on-lan functionality, in order to update the TV's "ON" status after I turn it off via the above IP command, is there a way to periodicaly check if a specific IP is alive (via ping?) or a specific domain name is alive (it always register to DHCP as "COM-MID1") in my LAN?
Than you in advance.
I will give it a try and report back.
I have successfully add a user library with those functions and then have send a "NRC_POWER-ONOFF" code to the TV and it worked!! Thank you very much!
I will now try to complete the rest of the commands and - if possible - to create a simple panel to simulate the remote control via the LM visualization!
One last question, since this TV is not powered via a bus-controlable outlet, and also does not support any wake-on-lan functionality, in order to update the TV's "ON" status after I turn it off via the above IP command, is there a way to periodicaly check if a specific IP is alive (via ping?) or a specific domain name is alive (it always register to DHCP as "COM-MID1") in my LAN?
Than you in advance.