This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.
Logic Machine Forum › LogicMachine eco-system › Hardware v
LM access but not giving Commands to KNX

Linear Mode
LM access but not giving Commands to KNX
vmic Offline
Member
Posts: 91
Threads: 22
Joined: Oct 2020
Reputation: 0
#3
06.04.2021, 09:28
(06.04.2021, 08:19)Daniel. Wrote: Did you select correct KNX Mode? System-Network-KNX connection. It should be TP-uart.

Oh yes I had it as IP Tunneling! Thank you very much!
Find
Reply


Messages In This Thread
RE: LM access but not giving Commands to KNX - by vmic - 06.04.2021, 09:28

Forum Jump: