15.03.2023, 11:00
How long is the cable? Are there any other CANx devices on the bus?
Try this:
1. Run line scan to detect the DALI gw. See if green LED blinks on the gw.
2. Switch to the Monitor tab, press "Start monitor" and press the programming button on the DALI gw. See if you get a message from it.
3. Click Tools -> Enable direct communication. You might also need to reset the DALI gw by long pressing the programming button.
Try this:
1. Run line scan to detect the DALI gw. See if green LED blinks on the gw.
2. Switch to the Monitor tab, press "Start monitor" and press the programming button on the DALI gw. See if you get a message from it.
3. Click Tools -> Enable direct communication. You might also need to reset the DALI gw by long pressing the programming button.