This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.
Logic Machine Forum › LogicMachine eco-system › Scripting v
Read GA and update its value in the KNX Bus

Linear Mode
Read GA and update its value in the KNX Bus
Daniel Offline
Administrator
Posts: 4216
Threads: 21
Joined: Aug 2017
Reputation: 178
#4
17.10.2023, 13:52
Grp.read is the same command, check in ETS group monitor if the read and answer is seen on the bus.
You should contact gateway manufacture as it may need some special configuration.
------------------------------
Ctrl+F5
Find
Reply


Messages In This Thread
RE: Read GA and update its value in the KNX Bus - by Daniel - 17.10.2023, 13:52

Forum Jump: