29.05.2017, 21:17
Hello i am using LM for some years, and are happy with it.. Now i got to test an Spacelynk from Schneider.
But it stops just after a couple of hours. As you can see on the connected picture it peaks on 100 %. Everything works normal, but the knx communication stops and nothing goes on out or in of the Spacelynk and nothing goes out on the Ets group monitor.
If i disconnect the knx line and wait a moment and then connect back on, the Spacelynk will start again.
Really annoying. I have just updated the firmware and still the same behavier.
Anybody know anything about this..
But it stops just after a couple of hours. As you can see on the connected picture it peaks on 100 %. Everything works normal, but the knx communication stops and nothing goes on out or in of the Spacelynk and nothing goes out on the Ets group monitor.
If i disconnect the knx line and wait a moment and then connect back on, the Spacelynk will start again.
Really annoying. I have just updated the firmware and still the same behavier.
Anybody know anything about this..