Logic Machine loses all progress after reboot/power failure

[Integrator21]

Hello,

I have a LM reactor 3, the problem is that after each power failure it does not save any changes, it stays the same, it worked for 2 years, the last changes I made do not save, I tried restoring from backup, it still display the initial image... it's like the SD card as a write protection and cannot save any more changes, any suggestions please?

[Daniel]

Common issue for old hw. Card is in read only mode and has to be replaced.

[Integrator21]

Common issue for old hw. Card is in read only mode and has to be replaced.

Is there a tutorial for this operation? thank you , If i upgrade to the latest firmware is the old backup compatible?

[Daniel]

Fallow this https://openrb.com/reflash-logicmachine3...-software/
Yes old backup should work fine on new fw.

[Integrator21]

Fallow this https://openrb.com/reflash-logicmachine3...-software/
Yes old backup should work fine on new fw.

Hello, unfortunately I changed the SD card, updated to the latest firmware the issue is the same, the model is LM Reactor V3 , I used the regular CPU (i.MX28) LM Reactor V3 version, any suggestions? the issue is the same, it does not save changes

[Daniel]

Did you replace card with new?

[Erwin van der Zwart]

Probably disconnection power before save interval, then nothing is saved, either close down by system - power off or press sync button before cutting the power..

[Integrator21]

Probably disconnection power before save interval, then nothing is saved, either close down by system - power off or press sync button before cutting the power..

Is there away to check the save interval? or a setting for that?

---

Did you replace card with new?

Yes, 2 sd cards

[Daniel]

It is every 30min, or if you pres sync project then it does it instantly.

[Integrator21]

It is every 30min, or if you pres sync project then it does it instantly.

Thanks, it works great