This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.

LM5lite KNX Test and updated Documentation?
#1
I have a LogicMachine lite installed. 
I did the initial configuration and enabled KNX IP feature. Is it possible to thest the KNX Bus if the connection is ok?
Second small question  is there an updated Documentation?

Regards
Heinz
Reply
#2
You will see KNX connection status in bottom right corner if TP-UART mode is enabled. Latest docs are on our site under each product.
------------------------------
Ctrl+F5
Reply
#3
Thank you. I got it.
I asked regarding the updated documentation because on the documents first page is noted "Document Issue 1.0
November, 2016".
Regards
Heinz
Reply


Forum Jump: