High CPU Load

[khalil]

Hello
I have a high CPU Load. I look at the commands in processes app and there is a command KNX backend which loading the SL
What could be the issue.

[admin]

Check KNX TP and IP load. You might have a loop somewhere which causes a lot of traffic.

[khalil]

Thanks Admin
Here is the knx statistics screen shot.
I have IP Routers 
also I have two SL but they are not connected to the same TP

[admin]

Do you have KNX/IP filtering enabled? Maybe there are many message on the IP backbone? If messages are filtered they won't appear in the statistics but might cause high CPU load.
Disable KNX/IP features and check if the load is still high. Then you can switch from KNX/TP to IP mode temporarily to check if KNX/TP is at fault.