This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.
Logic Machine Forum › LogicMachine eco-system › General v
remote knx

Threaded Mode
remote knx
balatis Offline
Member
Posts: 150
Threads: 27
Joined: May 2017
Reputation: 2
#1
25.02.2018, 10:58
hello.
i would like to learn how is possible to do Remote KNX bus control and KNX device reprogramming
i use doname i have not static ip.
thanks  Huh
Find
Reply
admin Offline
Administrator
Posts: 7758
Threads: 42
Joined: Jun 2015
Reputation: 447
#2
26.02.2018, 10:45
You need to forward UDP port 3671 on your router and use NAT mode in ETS. But from a security point of view it's much better to use VPN.
Find
Reply
balatis Offline
Member
Posts: 150
Threads: 27
Joined: May 2017
Reputation: 2
#3
12.03.2018, 17:55 (This post was last modified: 12.03.2018, 17:56 by balatis.)
thanks for the answer .i have a problem with telegram. some times send a local telegram my homelynk on it's own as a result to start a/c ,open some lights
have you any ideas why? in the source address write local
thank you ....
Find
Reply
Daniel Offline
Administrator
Posts: 4643
Threads: 24
Joined: Aug 2017
Reputation: 207
#4
12.03.2018, 18:45
It can't send on its own. Disable all your scripts, sync, reboot and check again. Also check scheduler.
------------------------------
Ctrl+F5
Find
Reply


Forum Jump: