Posts: 389
Threads: 100
Joined: Oct 2016
Reputation:
9
Hi
What is my LM trying to say by this red ERROR flag?
https://www.dropbox.com/s/dls8nzzq3zozuf...6.png?dl=0
I can't find any suitable explanation. I've two LMs at the same KNX TP line. First is OK but the second one is flashing between "OK" and "ERROR" message. System log is empty. KNS statistic says nothing. No alarms. No Errors nor log.
Both LMs work.
What can be the problem?
Thank you
LM5Lp, firmware: 2018.08.22, FlashSYS v2, ARMv7 Processor rev 5 (v7l), kernel 4.4.151
Posts: 3715
Threads: 22
Joined: Jun 2015
Reputation:
185
Do you have KNX IP features enabled on both devices? What is CPU/IO load on LMs?
Posts: 389
Threads: 100
Joined: Oct 2016
Reputation:
9
23.11.2017, 09:57
(This post was last modified: 23.11.2017, 10:00 by Thomas.)
Hi
Do you have KNX IP features enabled on both devices?
- KNX IP is switched on on the "broken" LM only. I've made a printscreen of both settings:
https://www.dropbox.com/s/7f3q9qmwjg5fjk...6.png?dl=0
Loads:
Working LM: Load averages
0.28 0.17 0.18
Broken LM:
Load averages
0.03 0.14 0.19
Unfortunately I can't find anything wrong. Just the message.
LM5Lp, firmware: 2018.08.22, FlashSYS v2, ARMv7 Processor rev 5 (v7l), kernel 4.4.151
Posts: 3715
Threads: 22
Joined: Jun 2015
Reputation:
185
Do have KNX connected/disconnected messages in Alerts tab?
Posts: 389
Threads: 100
Joined: Oct 2016
Reputation:
9
No. There's nothing suspicious in logs.
Here you can see my alerts log. One disconnect per three days aprox:
https://www.dropbox.com/s/x5hjrvifsoyq8q...0.png?dl=0
LM5Lp, firmware: 2018.08.22, FlashSYS v2, ARMv7 Processor rev 5 (v7l), kernel 4.4.151
Posts: 389
Threads: 100
Joined: Oct 2016
Reputation:
9
Actually my broken LM just died and is on the way to my office.
So I think the problem was some seriuos HW issue in this LM. First I will try to change the SD card inside.
LM5Lp, firmware: 2018.08.22, FlashSYS v2, ARMv7 Processor rev 5 (v7l), kernel 4.4.151