This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

1-wire not working
#1
Hi!

I tried do connect several 1-wire sensors to the 1-wire output.
connected GND + 1-Wire + 5V. like the drawing in the manual.
I measured 5V between GND an +5V
I measured 0.5V between GND and 1Wire.

but my Reactor V3 won't show anything in the web interface...

what other possibilities is there to find my fault?

BR

Bobby
Reply
#2
Idle state of 1-wire should be +5V, it's possible that 1-wire chip is damaged.
Reply
#3
(11.02.2018, 14:59)admin Wrote: Idle state of 1-wire should be +5V, it's possible that 1-wire chip is damaged.

Inside the Reactor?

(11.02.2018, 15:00)Bobby Wrote:
(11.02.2018, 14:59)admin Wrote: Idle state of 1-wire should be +5V, it's possible that 1-wire chip is damaged.

Inside the Reactor?

what are my options then?
Reply
#4
You can send the device back to us for repair, please contact us via e-mail.
Reply


Forum Jump: