This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

homelynk img
#1
Hello 
am having an issue with my homelynk : it contains an old version of a project i did , and it doesn't save any modification i do once i cut off the power .
i did a factory reset , and a firmware update , always back to the same old version 
Anything to do ?? thank youu
Reply
#2
You need to replace SD card because it probably became read-only.
Reply
#3
(14.03.2018, 09:23)admin Wrote: You need to replace SD card because it probably became read-only.

should i just replace it ?  there is any soft or installation to do ??
Reply
#4
(14.03.2018, 10:40)YOUSSEF Wrote:
(14.03.2018, 09:23)admin Wrote: You need to replace SD card because it probably became read-only.

should i just replace it ?  there is any soft or installation to do ??

yes  here
if it is old one then use this recovery firmware

BR
Reply
#5
(14.03.2018, 10:50)Daniel. Wrote:
(14.03.2018, 10:40)YOUSSEF Wrote:
(14.03.2018, 09:23)admin Wrote: You need to replace SD card because it probably became read-only.

should i just replace it ?  there is any soft or installation to do ??

yes  here
if it is old one then use this recovery firmware

BR

does the recovery is the same for homelynk ??
Reply
#6
yes it is the same
Reply
#7
(14.03.2018, 17:40)Daniel. Wrote: yes it is the same

well thank you for your support 
i had to change the SD card , apparently it's dead
Reply


Forum Jump: