This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.

CANx devices programming over LoRa
I noticed I can't program a CANx device over LoRa wireless, I need to plug the CANx bus to do it. Is that correct?

That would be a limitation when I need to reprogram an installed device...


Yes this is correct. It was hard decision but security point of view forced us to do it this way.

Forum Jump: