|
Changing negative value to zero
|
02.06.2021, 12:17
With this arrangement I can delay the message a bit, but it still messes a bit with the DM calculation of the heatpump because the delay can only be set to 60sec. Is there any way that I can prevent the data being sent to bus when the DM gets above 0 or run this script only when the DM is below zero?
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Changing negative value to zero - by RagingBull - 02.06.2021, 04:30
RE: Changing negative value to zero - by admin - 02.06.2021, 06:00
RE: Changing negative value to zero - by RagingBull - 02.06.2021, 08:03
RE: Changing negative value to zero - by admin - 02.06.2021, 08:06
RE: Changing negative value to zero - by RagingBull - 02.06.2021, 08:11
RE: Changing negative value to zero - by Daniel - 02.06.2021, 08:13
RE: Changing negative value to zero - by RagingBull - 02.06.2021, 12:17
RE: Changing negative value to zero - by admin - 02.06.2021, 13:44
|
