This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.

Knx Spacelogic programming with W4KNX / Spacelynk
#1
Hello, I have lots of issue on several customer site to program the MTN6705-0008 for example with the Spacelynk or Homelynk KNX Ip interface. It's very often buging to 50% then stop programming due to not respons. No problem with older device
 
If I retry with my Spacelogic USB interface no problem.
I try 2.6,2.6.1,2.6.2 all same !!
 
Big problem for our remote customer
-----------
FRANCE SMARTHOME & SMARTBUILDING INTEGRATION
SE ECO EXPERT
Reply
#2
I sent this to SE support to check. Not much we can do.
------------------------------
Ctrl+F5
Reply
#3
(16.09.2021, 10:48)Daniel Wrote: I sent this to SE support to check. Not much we can do.

Thank I post to exchange too, I guess it's due to the long frame support, secure...
-----------
FRANCE SMARTHOME & SMARTBUILDING INTEGRATION
SE ECO EXPERT
Reply


Forum Jump: