This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.

Wiser for KNX boot failure

After several power failures my LSS100100 (HW 1.1) controller is not work propertly: web-interface randomly freezes, blank pages, settings is not stored after reboot. So, i conclude, that SD-card is broken and replaced it with new-one (16 GB samsung 10 class). I flashed SD-card with recovery-image than opened recovery page and chosed new firmware process started and than after 2 minutes controller rebooted and now only blinking with two LEDs (LED1 and internal LED) with 3 seconds period. Ethernet LEDs is also off and no pings to presented. What i am doing wrong?

with best regards

If you fallowed the description in the AN then there is not much can be done. Can be HW damage.

Forum Jump: