This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.

Device programming

I am having trouble to setup some CanX devices i had from the promo kit.

When i try to write device address via the CANx app, the procedure stucks on "Now press the programming button on the device". Line scan also does not find any devices.
I have tryied on diferent devices, browsers, PC's without success.

I also tryied to flash new software on the CANx devices but again my PC's fails to correctly recognize the USB device .

My hardware: LM5p2-KC, CAN-R4-LoRa, CAN-UIO8-LoRa, PC's running Windows 10 & Windows 11

Any thoughts?

Attached Files Thumbnail(s)
Most likely you must flash the devices to latest firmware. In the location on your PC where DFU is installed there is pdf file which explains how to install the drivers. Try to fallowing this.
How to flash you can see here:

Forum Jump: