script for scene change

[Vik]

Hi,
I need a script for changing scene’s in a sequence ( scene1 … scene10 ) when we do a short “press-up” or “press-down” on a knx keypad.
 Example when we short “press-up”  the first time scene1 is triggered and it progresses to scene10 on the 10th short press. On the 11th short press scene1 is triggered again .
Similarly, when we do a short “press-down” the scene10 to scene9 and so on. In this case when we reach scene1 we jump scene10 after the short “press-down”.


thnx
vik

[admin]

Attach your scenes to 1 byte unsigned object with trigger value from 1 to 10. Create an event script for scene up/down (1 bit). Change scene trigger object (32/1/17) as needed.

Code:

out = '32/1/17'

up = event.getvalue()
nr = grp.getvalue(out)

if up then
  nr = nr + 1
  if nr > 10 then
    nr = 1
  end
else
  nr = nr - 1
  if nr < 1 then
    nr = 10
  end
end

grp.update(out, nr)

[Vik]

Hi,
I need a script for changing scene’s in a sequence ( scene1 … scene10 ) when we do a short “press-up” or “press-down” on a knx keypad.
 Example when we short “press-up”  the first time scene1 is triggered and it progresses to scene10 on the 10th short press. On the 11th short press scene1 is triggered again .
Similarly, when we do a short “press-down” the scene10 to scene9 and so on. In this case when we reach scene1 we jump scene10 after the short “press-down”.


thnx
vik

Thanks I will try this script

---

Hi,
We need your hrlp on another script.

We would like to disable a ceiling mount motion sensors whenever we do a "long-press" ( relative dimm).

To disable the sensor we need a 1-bit data while the relative dimm is a 4bit data type.

We need a script which can disable the sensor whenever a long press is done.

regards,
vik

[Daniel]

Just create event script on the dim object, change group as needed and if the disable value is 0 then change true to false

Code:

-- write value (e.g. boolean 'true') to object with group address 1/1/1, datatype must be set for this object
grp.write('1/1/1', true)

[Vik]

Attach your scenes to 1 byte unsigned object with trigger value from 1 to 10. Create an event script for scene up/down (1 bit). Change scene trigger object (32/1/17) as needed.

Code:

out = '32/1/17'

up = event.getvalue()
nr = grp.getvalue(out)

if up then
  nr = nr + 1
  if nr > 10 then
    nr = 1
  end
else
  nr = nr - 1
  if nr < 1 then
    nr = 10
  end
end

grp.update(out, nr)

Thank you for this. it worked fine.

---

Just create event script on the dim object, change group as needed and if the disable value is 0 then change true to false

Code:

-- write value (e.g. boolean 'true') to object with group address 1/1/1, datatype must be set for this object
grp.write('1/1/1', true)

Thanks a lot for this. This worked fine too.