Bus monitor in ETS through LM

[bmodeco]

Hi,
I am using the LM5 to program my KNX-devices through ETS-software which works as expected.
When using the monitoring in ETS I only get info when using the group-monitor: it shows all group adresses being triggered realtime.
However when I use the bus-monitor nothing shows up? Is this normal behaviour? Or do I need to change a setting in LM to do this.
Thansk, Bart

[admin]

Bus monitor is not supported

[bmodeco]

Bus monitor is not supported

Hi admin,
thanks for your quick response - did some googling: need a separate IP interface to do this.
Best regards, Bart

[Thomas]

Hi
Is there some way how to get bus monitor running? Newer firmware or settings?
Or maybe there's a better way. I'm looking for source of TP repeats. It's not critical but I'm getting 10 repeats per hour. Is it possible to investigate it through LM?
Thank you

[Daniel]

Nothing has changed, only group monitor will work.

[admin]

Try enabling "ACK all group telegrams" and see if it makes a difference on the number of repeats.

[JRP]

If an IP interface is used, the bus monitor does not work even in the ETS.

Greetings

[Daniel]

You probably creating KNX loop with your interface.