This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.

KNP/TP :Connected ????
#1
On LM3, the "alert" when you press the function.

it appears the words "knp / TP: Connected" very much. interrupting system LM3
At the same time there is also the error log "KNX / TP Transmitter error (send 0 receive 1)"
how to remove "KNX / TP connected" in the alert. ??  interrupting system LM3
thank all!
Reply
#2
KNX/TP might be overloaded, if you have several LMs on a single KNX/TP line they might cause a telegram loop. If this happens then "KNX/IP features" must be disabled in all but one LM.

Otherwise, if KNX/TP is not overloaded, send us your LM for replacement. Please contact us by e-mail for further actions.
Reply


Forum Jump: