19.07.2019, 11:42
Hello
Water gauges returns pulses only. I can send these pulses through KNX bus and count them in LM.
But how to do it correctly?
If I use GO only then I can't do backup and restore for example.
If I store values on SD card after every pulse I'm in risk I will kill it quickly.
How do you solve this problem?
Water gauges returns pulses only. I can send these pulses through KNX bus and count them in LM.
But how to do it correctly?
If I use GO only then I can't do backup and restore for example.
If I store values on SD card after every pulse I'm in risk I will kill it quickly.
How do you solve this problem?
LM5Lp, firmware: 2018.08.22 and 2021.12.15, FlashSYS v2, ARMv7 Processor rev 5 (v7l), kernel 4.4.151 and 4.4.259