PID script

[josdegroot]

Hi,

You don’t need to use the Siemens interface as the controller does the same functions, you can remove it. if you keep using it then disable KNX IP features in the KNX settings.

BR,

Erwin

check disabled the checkbox @ the logic machine.

Does it make sense that I have the address 1.1.100 for the logic machine?

Will check if the script is working fine now.

---

I see that the IP loop is gone . not 4 messages anymore .

But the Switch actor doesn't respond to the On or Off messages the logic machine is sending to group 12/0/7. (See attachment)

If I put A switch object from a taster in this group everything works fine...