I don't know if it's relevant but my LM is in TPUART mode and the KNX is programmed and debugged in ETS5 via LM
Thank you.
In case these datagrams are not routed to TP in any way then it's OK.
(20.10.2016, 22:23)Erwin van der Zwart Wrote: Hi,
There is a KNX telegram send over IP so ETS will show messages. However there is none on the twisted pair (TP).
TP is more critical for keeping clean as it can handle restricted amount of data, IP has not that restriction so makes no sense to reduce trafic on IP.
If you don't want the IP telegram send you can / should block it in the filter table.
BR,
Erwin
Thank you.
In case these datagrams are not routed to TP in any way then it's OK.
LM5Lp, firmware: 2018.08.22 and 2021.12.15, FlashSYS v2, ARMv7 Processor rev 5 (v7l), kernel 4.4.151 and 4.4.259