27.01.2022, 10:33
(This post was last modified: 27.01.2022, 10:45 by Thomas.
Edit Reason: System log attached
)
Hi
I'm not sure but it looks like there's a booting sequence issue in the new firmware. KNX interface starts before SD card is ready or something similar.
What I've done:
1. I backed up LM1
2. I restored the backup at LM2
Then after boot I got "Cannot open user script" error in error log (see the picture below).
System log attached ( time in system log seems to be in UTC)
I'm not sure but it looks like there's a booting sequence issue in the new firmware. KNX interface starts before SD card is ready or something similar.
What I've done:
1. I backed up LM1
2. I restored the backup at LM2
Then after boot I got "Cannot open user script" error in error log (see the picture below).
System log attached ( time in system log seems to be in UTC)
LM5Lp, firmware: 2018.08.22 and 2021.12.15, FlashSYS v2, ARMv7 Processor rev 5 (v7l), kernel 4.4.151 and 4.4.259