24.10.2023, 09:33
(This post was last modified: 24.10.2023, 09:35 by batistacaceres.)
(18.01.2023, 10:07)Ceros2112 Wrote: Nope, if I set lm5 to tunnelling I can't even reach it via ETS. I'll do some other tests though.
Have you solve it, I have the same problem. How can I access to program knx devices below IProuters?
When I access to knx network using zerotier, and my logicMachine is configured with address (1.1.0), as line acopler. Now I can only program knx devices located in line 1.1.x, but I can not access knx devices below IPRouter (1.2.0), even when they are in the same network switch.
I have tried, like you do, LM5 to tunnelling, but I can not reach via ETS.
Have you solve the problem?
best regards
Roger
(18.01.2023, 10:11)Daniel Wrote: Check PM and let me know if it works.
Hello:
What´s PM?
Have you solve it?, I have the same problem. How can I access to program knx devices below IProuters?
When I access to knx network using zerotier, and my logicMachine is configured with address (1.1.0), as line acopler. Now I can only program knx devices located in line 1.1.x, but I can not access knx devices below IPRouter (1.2.0), even when they are in the same network switch.
I have tried, like you do, LM5 to tunnelling, but I can not reach via ETS.
Have you solve the problem?
best regards
Roger
(18.01.2023, 10:11)Daniel Wrote: Check PM and let me know if it works.
Hello:
What´s PM?
Have you solve it?, I have the same problem. How can I access to program knx devices below IProuters?
When I access to knx network using zerotier, and my logicMachine is configured with address (1.1.0), as line acopler. Now I can only program knx devices located in line 1.1.x, but I can not access knx devices below IPRouter (1.2.0), even when they are in the same network switch.
I have tried, like you do, LM5 to tunnelling, but I can not reach via ETS.
Have you solve the problem?
best regards
Roger