Hi
Just a question about the design. Doesn't your push button or actuator support logical functions? Because what do you need are just 2x AND logic gates. I think the problem can be solved on KNX level. I would prefer this solution because of reliability and better bus load distribution.
Just a question about the design. Doesn't your push button or actuator support logical functions? Because what do you need are just 2x AND logic gates. I think the problem can be solved on KNX level. I would prefer this solution because of reliability and better bus load distribution.
LM5Lp, firmware: 2018.08.22 and 2021.12.15, FlashSYS v2, ARMv7 Processor rev 5 (v7l), kernel 4.4.151 and 4.4.259