04.04.2017, 11:28
But Hi
Is there a way how to use a secondary LM on the same bus as a hot spare device in case of the primary LM fails?
Or what is the best practice?
I've seen a simple example where scripts were disabled on the spare LM when the primary LM was available on the KNX bus. But it didn't disable schedulers etc.
Is there a way how to use a secondary LM on the same bus as a hot spare device in case of the primary LM fails?
Or what is the best practice?
I've seen a simple example where scripts were disabled on the spare LM when the primary LM was available on the KNX bus. But it didn't disable schedulers etc.
LM5Lp, firmware: 2018.08.22 and 2021.12.15, FlashSYS v2, ARMv7 Processor rev 5 (v7l), kernel 4.4.151 and 4.4.259