11.02.2026, 11:27
Hello!
I want to create a script that reads/checks a few groupadresses that are 6-byte and only look for a specific part of the 6-byte and if that part is '30'.
Then make an OR-gate that asks if any of my groupadresses shows 30 in the specific byte [6] send out true to a new groupadress else false.
See attached pictures. In logicmachine it is recorded as 'LTRF 3'. And in KNX it is shown as '30'.
Either a persistant script or I need the 6-byte adresses to start the other script that checks for the right byte.
I have tried for a while but cant come up with a solution!
Hope you understand my question.
Thanks for any help.
Best regards,
Tobias
I want to create a script that reads/checks a few groupadresses that are 6-byte and only look for a specific part of the 6-byte and if that part is '30'.
Then make an OR-gate that asks if any of my groupadresses shows 30 in the specific byte [6] send out true to a new groupadress else false.
See attached pictures. In logicmachine it is recorded as 'LTRF 3'. And in KNX it is shown as '30'.
Either a persistant script or I need the 6-byte adresses to start the other script that checks for the right byte.
I have tried for a while but cant come up with a solution!
Hope you understand my question.
Thanks for any help.
Best regards,
Tobias