15.06.2017, 14:38
Hi
I would like to show a mix of custom values and the original values. In short: If the replacement in custom values table exists use the custom value. In all other cases use the original object's value. Is it possible?
What's going on:
My problem are blinds. I want to show "Up" value for upper position (0%) and "Down" for lower position (100%) of blinds. And numbers for every other value.
I understand I can put all values (1%,2%..99%) into the custom values table but this is not what I want to do.
Do you have any suggestion?
I would like to show a mix of custom values and the original values. In short: If the replacement in custom values table exists use the custom value. In all other cases use the original object's value. Is it possible?
What's going on:
My problem are blinds. I want to show "Up" value for upper position (0%) and "Down" for lower position (100%) of blinds. And numbers for every other value.
I understand I can put all values (1%,2%..99%) into the custom values table but this is not what I want to do.
Do you have any suggestion?
LM5Lp, firmware: 2018.08.22 and 2021.12.15, FlashSYS v2, ARMv7 Processor rev 5 (v7l), kernel 4.4.151 and 4.4.259