09.11.2017, 14:52
I'm experiencing a problem with the Modbus mapper and my SMA inverter.
I have been able to load a correct profile for 1 register and map it to a knx object.
Poll interval is set at 10seconds. I see that the KNX object is correctly updated a first time. However, any changes afterwards are not refreshed in the KNX object.
Is there anything else that I would need to investigate? If I remove the mapping and create a new one, the value gets written again only once.
Anybody any clue?
regards,
Joost
I have been able to load a correct profile for 1 register and map it to a knx object.
Poll interval is set at 10seconds. I see that the KNX object is correctly updated a first time. However, any changes afterwards are not refreshed in the KNX object.
Is there anything else that I would need to investigate? If I remove the mapping and create a new one, the value gets written again only once.
Anybody any clue?
regards,
Joost