12.06.2018, 16:49
(12.06.2018, 15:02)NLCarrII Wrote:(11.06.2018, 21:47)Erwin van der Zwart Wrote: Hi,
Have you tried this sample already? (not sure if it is also for your device)
http://openrb.com/example-use-lm2-as-tcp...e-theater/
BR,
Erwin
That could be where I am having issues. All I am doing is connecting to the IP Address of my Denon on Port 23. I am then sending individual commands. MVUP<CR> for example. After some more research, I cannot remember where, it said that the Denon is looking for a "packet" of information and it must be received in 40ms. I am only sending the single string.
What I am trying to accomplish is this... I have an M1G Security System with an M1XEP Ethernet Expander. I can send IP strings from the M1XEP to another IP Address and Port (hopefully the Denon Receiver). When I disarm the alarm, I want the M1XEP to send strings to the Denon to turn on, go to a specific source, and raise the volume to 45. I have accomplished this with an older Integra Receiver with no issues, so I am baffled by this on the Denon.
ELK Products also makes an M1XSP Serial Expander that I could connect straight serial to the Denon, but so far testing with my computer and a USB-Serial cable is not working either. The M1XSP also works with the Integra receiver.
This may also be the wrong community, but I am hoping some of this knowledge is transferable.
When you first send the command to turn the Denon ON (PWON) , you have to wait 1 second before sending the next command.