This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.

[OLD] LogicMachine firmware 2022 RC1
#8
Hi, I found a bug after upgrade with lm5m3ex-20221205.img yesterday.
Software ETS5 can recognize LM5 as a IP Tunneling port(in BUS->Connection->Interface page, test OK), but can't use LM5 as a KNX commissioning tool like before.
When I monitor or test KNX system with LM5, like force 0/0/1(switch) ON or OFF, but nothing response from KNX switch module.
I don't know why and how to solve it.
Thanks a lot for your attention.


Messages In This Thread
RE: [PRE-RELEASE] LogicMachine firmware 2022 RC1 - by richard7 - 08.12.2022, 02:01

Forum Jump: