Reactor and power relè card

[gdimaria]

Hi,

I wanted to try using Reactor to drive a 4-input power relay board (5 volt powered) as in the attached pictures.

I think I did everything correctly, but it doesn't work: the leds on the board go on and off, but relays dosn't act.

The same board, however, connected to Arduino board works perfectly.

Can you help me?

Thank you

[Daniel]

Why did you connect it to 1wire and only partially?

[gdimaria]

Why did you connect it to 1wire and only partially?

Actually, as you can see, I connected 5 volts, not 1 wire

[admin]

This won't work - these relays are meant for 5V operation, LM outputs 24V. Just use normal 24V relays instead.

[gdimaria]

This won't work - these relays are meant for 5V operation, LM outputs 24V. Just use normal 24V relays instead.

OK, thank you!

Peppe