R6HC

[KoBra]

I am trying to control a R6HC but as soon as i give a 1 to a relay it goes on and off the next second.

I use Relay and status, they both change in LM but go back. If i directly write value in the CANX interface it stays on so it seems there is something i am missing between LM and CANX

[RomansP]

Hello,

What load have you connected to relay - how many ampers and what type of load - is it electric motor or something else?

[KoBra]

nothing yet at the moment
will be small pumps

[RomansP]

Can you perform a hard reset for R6HC (by pressing programming button for more than 4 seconds), after reset check the working of relay. Also check if there are any scripts that can control the boolean object that controls the relay.