This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

Device LED blinking meaning
#1
Is there any info about devices Activity LED blinking?
On our device it's blinking green/red
Reply
#2
Please see LED meaning attached.

Attached Files Image(s)
   
Reply
#3
"Heartbeat" flash frequency is a hyperbolic function of the 5-minute load average. The higher the system load, the faster it will blink.
Reply
#4
LED1 shows current system load, LED2 turns green when system is fully loaded.
Reply
#5
(22.03.2017, 13:26)admin Wrote: LED1 shows current system load, LED2 turns green when system is fully loaded.

Hi

Is this information valid for LM5 too?
Thank you
LM5Lp, firmware: 2018.08.22, FlashSYS v2, ARMv7 Processor rev 5 (v7l), kernel 4.4.151
Reply
#6
All devices behave the same.
Reply
#7
(22.03.2017, 12:46)leondias Wrote: Are you talking about LED1 or LED2?

As I mentioned, LED2 is now blinking red-green. Yesterday it was only green

Hi,

You probably have enabled the device identification, this works like blinking LED on KNX device to determine what device you have, this is usefull when having multiple controllers.

Try: Utilities -> Click on the black arrow inside the System button -> Toggle device identification

BR,

Erwin
Reply
#8
(23.03.2017, 12:29)Erwin van der Zwart Wrote:
(22.03.2017, 12:46)leondias Wrote: Are you talking about LED1 or LED2?

As I mentioned, LED2 is now blinking red-green. Yesterday it was only green

Hi,

You probably have enabled the device identification, this works like blinking LED on KNX device to determine what device you have, this is usefull when having multiple controllers.

Try: Utilities -> Click on the black arrow inside the System button -> Toggle device identification

BR,

Erwin

Thanks, you are right Smile
Reply


Forum Jump: