Reset KNX device without ETS

[Trond Hoyem]

Try RC1: https://forum.logicmachine.net/showthread.php?tid=2313

OK, that was a bad idea....

Now there is no access to the LM4 at all, and I am working remotely as it is Covis-time all over... Is ther any way to restart, reboot, do anything at all when I just get a blank page at the IP-address?

[admin]

Can you try accessing page directly, like /flashsys/ or /scada-main/ ? Open browser dev tools (F12) and check the response code when accessing pages. Is it 200 or 503 or something else?

[Trond Hoyem]

Can you try accessing page directly, like /flashsys/ or /scada-main/ ? Open browser dev tools (F12) and check the response code when accessing pages. Is it 200 or 503 or something else?

I got the hold of a guy there, so he switched the power off and on, and now it works. So no problems anymore :-)

[daniil_perov]

This feature will be available in the next version

Code:

knxlib.restart('1.1.100')

Code:

require('knxlib')
value = event.getvalue()
if (value == true) then
    knxlib.restart('1.1.22')
  log (value)
end

The code seems to be doing nothing.
I get the log, but not the reset of the device
I've tried to include the library, but it had not helped

Hope someone can point out my mistake.
Best regards!

[admin]

Is this KNX device connected directly to LM via KNX/TP? Reset won't work over KNX/IP.

[daniil_perov]

Is this KNX device connected directly to LM via KNX/TP? Reset won't work over KNX/IP.

KNX/IP is used.

Let me try.
Thank you!

[Joep]

Does this work on a W4k too as i don't get any result?

[Daniel]

It is implemented exactly the same on W4k but some knx devices may not work for this. Try first via ETS if it works there.

[Joep]

It is implemented exactly the same on W4k but some knx devices may not work for this. Try first via ETS if it works there.

I tried all of this but i don't get any result. The connection is over TP.

require('knxlib')

spanning = knxlib.readbusvoltage('1.1.1') -- returns bus voltage read from a given phys. address
log(spanning)

verbinding = knxlib.isconnected() -- returns true when KNX is connected, false otherwise
log(verbinding)

statistieken = knxlib.getstats() -- returns Lua table with KNX/IP and KNX/TP telegram stats
log(statistieken)

herstart = knxlib.restart('1.1.1')  -- restart KNX device with given phys. address
log(herstart)

ping = knxlib.ping('1.1.1')  -- ping KNX device with given phys. address
log(ping)

[Erwin van der Zwart]

On a W4k..