Delay for DALI !

[davidchispas]

You need to use queryactual instead of querystatus command.
Try this script:

Code:

require('user.dali')

function queryactual(short, addr)
  local res, err = dalicmd('internal', 'queryactual', { addrtype = 'short', address = short })
  if res then
    local val = res:byte()
    if val > 0 then
      val = math.floor(val / 2.54 + 0.5)
      val = math.max(1, val)
    end
    grp.checkupdate(addr, val)
  end
end

queryactual(0, '11/1/103')
queryactual(1, '11/1/104')

I need your opinion on how it is advisable to obtain the status of the ballasts in group.

For example, a group of 60 ballasts linked to the same control object. To visualize the real state I need to obtain at least the state of one of them, but in the event that in the future that ballast fails, could I assign the same address to the 60 ballasts?

To visualize the On / Off status, I added another line to the script, is that fine, or is it recommended to do it in another way?

Code:

require('user.dali')

function queryactual(short, addr)
  local res, err = dalicmd('internal', 'queryactual', { addrtype = 'short', address = short })
  if res then
    local val = res:byte()
    if val > 0 then
      val = math.floor(val / 2.54 + 0.5)
      val = math.max(1, val)
    end
    grp.checkupdate(addr, val)
  end
end

queryactual(0, '1/1/0') --Porcentage
queryactual(0, '1/2/0') --1Bit
queryactual(1, '1/1/0') --Porcentage
queryactual(1, '1/2/0') --1Bit
queryactual(2, '1/1/0') --Porcentage
queryactual(2, '1/2/0') --1Bit